Liquid Kicks: Top Coat High Gloss Finish

Liquid Kicks: Top Coat High Gloss Finish

Liquid Kicks: Top Coat High Gloss Finish is the ultimate solution for protecting and enhancing your art on various surfaces. With a volume of 2oz/4oz, this top coat offers exceptional quality and durability.

To achieve the highest level of gloss possible, it is recommended to apply this high gloss finish in three wet coats, allowing each coat to air dry for 10 minutes before using a hairdryer to complete the drying process. Rushing the drying process may result in an uneven surface and a lower gloss level.

LK Top Coats are unparalleled in the industry, providing superior protection for leather, vinyl, PVC, canvas, cotton, and silk. These top coats are scratch resistant, UV resistant, waterproof, and chemical resistant, ensuring that your custom leather, canvas, and vinyl products will not peel, lift, crack, or fade.

Preparation: Use a clean lint-free cotton cloth dampened with acetone to clean only the leather surface which you intend to paint. Do not excessively clean the surface. You should feel the surface change from slick to tacky as you are cleaning it. As soon as it changes feel, it has been sufficiently been cleaned. Allow the surface to sit for 10 to 20 minutes to allow solvents to escape. Do not force dry. Remove any dust or debris with a clean dry synthetic paint brush.

Applying Primer: LK Primer can be applied with a soft brush, but the best way to apply it is with an airbrush with a tip size between .2mm and .7mm with air pressure between 25psi and 35psi. Spray Primer directly at the surface from 3 to 5 inches away with an airbrush, or 4 to 8 inches away with a spray gun. Apply in even coats by working from side to side and top to bottom while overlapping each previous line to create medium wet coats. Allow the primer to fully dry before moving to the next coat. You may use a hairdryer to force dry but be sure to allow the surface to cool all the way before proceeding.

Pot Life: Once the product is poured into an open-air container such as an airbrush cup or mixing cup, curing will begin. A test showed that in a 1/8oz airbrush cup at 72f the product was usable for 2 hours before performance was affected. In a similar test in a 16oz cup, the product was usable for 6 hours. To extend pot life, keep unused portion covered with a cap or lid.

Coverage: One 2oz bottle will coat more than 15 pairs of leather shoes! Coverage on canvas will vary based on the type of canvas and size.

Storage: Store between 50f and 80f and away from long term exposure to direct sunlight to prevent oxidation. Long term exposure to temperatures over 120f and below 30f may cause a loss of product performance. Keep lid closed when not in use to prevent drying.

Clean up: Clean all tools immediately use with water, acetone or 4011 reducer by Createx Colors TM. Clean up of dried primer requires ammonia. Clean all traces of Primer out of your airbrush or spray gun immediately after use to prevent the product from drying inside the body and causing a difficult to remove clog! Rinse until cleaner no longer becomes foggy from Primer.

With Liquid Kicks: Top Coat High Gloss Finish, you can confidently showcase your art on various surfaces, knowing that it is protected, durable, and always looks good.