KBS Top Coater Premium Finish Aerosol Color: Aluminium

(No reviews yet) Write a Review
Gift wrapping:
Options available
Calculated at Checkout
On Sale
  • KBS Top Coater Premium Finish Aerosol Color: Aluminium
  • KBS Top Coater Premium Finish Aerosol Color: Aluminium
Now: $17.00
Was: $21.95
Frequently bought together:


KBS Top Coater Premium Finish Aerosol Color: Aluminium

Volume: 16 oz (454g)

KBS Top Coater is a superior spray paint formulated for maximum coverage and professional looking results. KBS Top Coater is an ideal top coat paint for RustSeal when the area will be consistently exposed to sunlight. KBS Top Coater is a very high solids paint, does not run or sag, and gives at least twice the coverage of conventional spray paints. KBS Top Coater can be applied to bare metal, but for ultimate performance, apply KBS Top Coater over RustSeal.

Theoretical Coverage:

  • 1 can of KBS Top Coater should coat up to 38 sq. ft. with 1 coat coverage.


Surface prep:

  • FOR BEST END RESULTS, apply KBS Top Coater to clean and dry surfaces that have been sealed with RustSeal.
  • If needed, use KBS Klean to remove all surface contaminants. (avoid solvent-based cleaners which leave invisible residues that can affect adhesion of KBS Top Coater).
  • To topcoat freshly painted RustSeal (between 3-8 hours old), apply KBS Top Coater directly as no other prep is required.
  • For all other applications, lightly sand/scuff with 320 grit paper then clean and dry surface before applying KBS Top Coater.



  • Always wear protective gloves and eye wear when using KBS Top Coater.
  • Always wear NIOSH/MSHA approved air supplied respirator.
  • for best results, spray at room temperature between 50-90 degrees Fahrenheit (10-32 degrees Celsius).
  • use only in moderate or dry atmospheric conditions (70% humidity or lower)
  • Shake can for at least 1 minute after listening for rattle, or mixing ball.
  • During application, shake intermittently for approximately 10 seconds at 1 to 2 minute intervals.
  • Press valve all the way down.
  • Do not extend finger beyond the valve.
  • Hold container 8 to 10 inches from surface to be sprayed.
  • Do not cover with continuous spray. Move back and forth releasing sprayhead after stroke. Overlap each stroke.
  • If clogging develops, turn sprayhead 1/4 turn, or remove and clean sprayhead.
  • IMPORTANT: Apply thin coats rather than heavy coats. If paint runs or sags, paint is being applied too heavily or paint can is too close to surface. Apply 1-2 thin covering coats for general automotive applications.
  • For marine or industrial applications, apply a minimum of 2-3 thin covering coats. Recoating can be done once first or consecutive coat is dry-to-touch. For best results always apply coats consecutively within 24 hours of each coat curing.
  • Average recoat cure times are 1-2 hours depending on humidity levels. Full cure is usually achieved within 24 hours.
  • To clear sprayhead for future use, turn can upside down and spray for 3 seconds.

*R - shipping restrictions apply. Can only ship via ground transport. No overseas shipping, no express shipping.

View AllClose

0 Reviews

View AllClose