Liquid Kicks: Top Coat High Gloss Finish

(No reviews yet) Write a Review
Usually Ships Within 24 hours!
Gift wrapping:
Options available
  • Liquid Kicks Top Coat High Gloss Finish LK-HIGHGLOSS Liquid Kicks
  • Liquid Kicks Top Coat High Gloss Finish LK-HIGHGLOSS Liquid Kicks
$12.00 - $20.00
Frequently bought together:


Liquid Kicks: Top Coat High Gloss Finish

Volume: 2oz/4oz 

High Gloss needs to be applied in 3 wet coats and dried fully between coats. We recommend allowing each coat to air dry for 10 minutes before using a hairdryer to finish the drying process. This air-drying time is critical to allowing the topcoat to flow out and form a smooth film that will allow for the highest level of gloss possible. Rushing the drying process will cause the film to dry with an uneven surface and lower the gloss level.


LK Top Coats are the highest quality leather topcoats in the industry! We designed our topcoats to protect your art on a variety of surfaces such as leather, vinyl, PVC, canvas, cotton, and silk. They are extremely scratch resistant, UV resistant, waterproof, and chemical resistant. LK Top Coats give you the ability to send your custom leather, canvas, and vinyl products out into the world with confidence that they will not peel, lift, crack or fade and they will always look good.

Preparation: Use a clean lint-free cotton cloth dampened with acetone to clean only the leather surface which you intend to paint. Do not excessively clean the surface. You should feel the surface change from slick to tacky as you are cleaning it. As soon as it changes feel, it has been sufficiently been cleaned. Allow the surface to sit for 10 to 20 minutes to allow solvents to escape. Do not force dry. Remove any dust or debris with a clean dry synthetic paint brush.

Applying Primer: LK Primer can be applied with a soft brush, but the best way to apply it is with an airbrush with a tip size between .2mm and .7mm with air pressure between 25psi and 35psi. Spray Primer directly at the surface from 3 to 5 inches away with an airbrush, or 4 to 8 inches away with a spray gun. Apply in even coats by working from side to side and top to bottom while overlapping each previous line to create medium wet coats. Allow the primer to fully dry before moving to the next coat. You may use a hairdryer to force dry but be sure to allow the surface to cool all the way before proceeding.

Pot Life: Once the product is poured into an open-air container such as an airbrush cup or mixing cup, curing will begin. A test showed that in a 1/8oz airbrush cup at 72f the product was usable for 2 hours before performance was affected. In a similar test in a 16oz cup, the product was usable for 6 hours. To extend pot life, keep unused portion covered with a cap or lid.

Coverage: One 2oz bottle will coat more than 15 pairs of leather shoes! Coverage on canvas will vary based on the type of canvas and size.

Storage: Store between 50f and 80f and away from long term exposure to direct sunlight to prevent oxidation. Long term exposure to temperatures over 120f and below 30f may cause a loss of product performance. Keep lid closed when not in use to prevent drying.

Clean up: Clean all tools immediately use with water, acetone or 4011 reducer by Createx Colors TM. Clean up of dried primer requires ammonia. Clean all traces of Primer out of your airbrush or spray gun immediately after use to prevent the product from drying inside the body and causing a difficult to remove clog! Rinse until cleaner no longer becomes foggy from Primer.

View AllClose

0 Reviews

View AllClose